Using Richard's link above, I downloaded 'Download for Windows 7/8/8.1 (v6.7.6)' and installed them using the executable in the zip for 圆4 OSes. When I looked up the VID and PID of the i.MX8M Quad EVK using the FTDI USBView utility I see:Ġx0409: 'CP2105 Dual USB to UART Bridge Controller' You should contact your vendor to determine if they will support Windows 7 圆4. If you have a product where the manufacture has customised the driver but has not re-certified it, then the driver will not load. It will also work with other FTDI VID and PID combinations. The certified driver supplied by FTDI will work with VID 0403 and PID 6001 for FT232 and FT245 devices. Windows 7 圆4 OS will only allow certified drivers to be installed. However, FTDI Instructions state (AN_119):

The serial-to-USB drivers are available at.

The smaller numbered port ( COM9) is for the serial console communication from Arm ® Cortex ®-A53 and the larger numbered port ( COM10) is for Arm ® Cortex ®-M4 core. Assume that the ports are COM9 and COM10. USB Drivers Download is best place to get exotic and hard to find drivers for your USB hardware. So far for me This weekend I was surprised by teasing image showing a working FTDI USB to. The FTDI USB-serial chip on i.MX8MQuad enumerates two serial ports. Ftdi usb to serial driver chip - Download Driver for your Windows 10/7/8/Vista/ & more from a authorized website. I managed to install the drivers, but my device wasnt recognized. Out of the Box -> Tera Term Tutorial) states: Serial communication console setup

The 8MQuad EVK page ( i.MX 8M Evaluation Kit|NXP -> Getting Started -> 1. Thank you, RichardBohl! I wasted a ton of time trying to get the USB to Serial ports (VCP) working on Windows 7 圆4 with NXP's incorrect instructions. FTDI Driver API for Serial by Ovak Technologies- Interface Synchronous Serial Devices to a USB Port FTDI Driver for I2C SPI GPIO by AJ - Read and Write SPI.

Ftdi usb to serial windows 10 driver